Threaded solar water heating element featuring a 1-inch BSP connection, probe hole, and multiple power options.
Solar Water Heater Elements
Solar water heater elements provide electric backup heating for solar hot-water tanks when solar energy alone is insufficient. They install into compatible tank connections and heat the stored water directly.
Select the correct thread, voltage, wattage, element length and material for the tank. Confirm clearance, sealing and controller compatibility before installation.
Recommended
DC immersion heating element with a 1-inch threaded connection and 304 stainless steel construction, designed for solar water heaters.
Need an exact replacement?
Send dimensions, voltage, power, material, and photos. We’ll manufacture a heating element for your application.
Fill out the formStraight 51 cm electric heating element for solar water heater tanks, operating at AC220V with built-in temperature control.
Straight electric heating element for solar water heaters featuring a 53cm 304SUS tube, 220V voltage, and 1500W power.
Straight electric heating element for water heater tanks featuring a 29 cm 304SUS tube and 1-inch thread connection.
3KW 220V electric immersion heating element with 1-1/4 inch BSP copper thread for water tanks.
AC220V electric heating element for solar water heaters and tanks, featuring 304 stainless steel construction and 1-inch threaded mounting.
Threaded 304 stainless steel electric immersion water heating element designed for water tanks and liquid heating.
Electric immersion water heating element with a DN32 threaded connection for solar water heaters and liquid heating applications.
Stainless steel water immersion heater element designed for solar tanks and vessels, available in multiple voltage and power ratings.
Threaded immersion heating element with 304 stainless steel tube and thread, suitable for water tanks, boilers, and oil stoves.
Frequently asked questions
Practical guidance for choosing and using products in this category.
Can an immersion heater be switched on without liquid?
An element designed for immersion must not be energised with its heated section exposed to air. Keep the required heated length covered by the specified liquid throughout operation, following the product instructions. Dry operation can cause rapid overheating and element failure.
Temperature control and suitable low-liquid-level protection should be part of the system design. Keep electrical terminals dry and have the installation checked by a qualified installer.
Are BSP, NPT and metric heater threads interchangeable?
No. These are different thread systems, and a similar diameter or nominal size does not mean the fittings will seal or fit correctly. Check the specified thread family, size, pitch and sealing arrangement on both the heater and the equipment.
DN is a nominal size designation, not a measured outside diameter. For example, do not select a mounting hole or adaptor from a DN label alone. If the thread cannot be positively identified, provide the equipment specification and clear measurements before ordering.
Is every stainless steel heater suitable for drinking water, brewing or pool water?
No. Suitability depends on the complete product, including the sheath, seals, fittings, liquid chemistry and operating conditions. A stainless steel grade by itself is not proof of food-contact, potable-water or pool suitability.
Choose a model whose documentation explicitly supports your application. For salt water, chlorinated water, food or drinking-water contact, confirm compatibility before ordering rather than relying on the product name or appearance.