Submersible 220V electric water heater element with fully sealed 201 stainless steel U-tube for buckets, pools, and water tanks.
Immersion Heaters
Immersion heaters transfer electrical heat directly into water, oil and other compatible liquids. Their tubular elements are designed to operate while immersed, making them suitable for tanks, vessels and process-heating equipment.
Compare voltage, power, element dimensions, sheath material and the intended liquid. Keep the heated section fully submerged during operation unless the product is explicitly rated for dry heating.
Recommended
Fully sealed waterproof 12V/24V electric immersion heater pipe made of 304 stainless steel, designed for fish tanks and small liquid heating.
Need an exact replacement?
Send dimensions, voltage, power, material, and photos. We’ll manufacture a heating element for your application.
Fill out the formFully sealed waterproof 304 stainless steel submersible cartridge heater tube for water heating applications, featuring 1M high-temperature wire.
Red copper electric water heater heating element operating at 220V with a 63mm flange and 8mm tube diameter.
304 stainless steel transverse spring electric water heating element designed for liquid heating applications.
Replacement electric heating element designed for water heater applications.
220V 1500W electric water heating element with a large round head for 39.5-40mm mounting holes, designed for quick liquid heating.
Low voltage submersible cartridge water heater featuring 304 stainless steel construction and a waterproof silicone cable for liquid heating.
24V U-shaped submersible immersion water heater pipe made of 304 stainless steel with waterproof wire for liquid heating.
Submersible low-voltage DC water heating tube made of 304 stainless steel with a waterproof silicone wire for small liquid and tank heating.
Flange heating element designed for electric steam boilers and ironing machines, featuring a round head and 380V operation.
Frequently asked questions
Practical guidance for choosing and using products in this category.
Can an immersion heater be switched on without liquid?
An element designed for immersion must not be energised with its heated section exposed to air. Keep the required heated length covered by the specified liquid throughout operation, following the product instructions. Dry operation can cause rapid overheating and element failure.
Temperature control and suitable low-liquid-level protection should be part of the system design. Keep electrical terminals dry and have the installation checked by a qualified installer.
Is every stainless steel heater suitable for drinking water, brewing or pool water?
No. Suitability depends on the complete product, including the sheath, seals, fittings, liquid chemistry and operating conditions. A stainless steel grade by itself is not proof of food-contact, potable-water or pool suitability.
Choose a model whose documentation explicitly supports your application. For salt water, chlorinated water, food or drinking-water contact, confirm compatibility before ordering rather than relying on the product name or appearance.
Can an immersion heater run continuously?
Only when the selected model and the complete installation are rated for that duty. Continuous operation requires suitable heat removal, the specified liquid coverage, temperature control and protection against overheating or low liquid level.
Check the product duty rating and the tank or process requirements. A wattage rating alone does not confirm that a heater can run unattended or continuously in every installation.