Product Overview
This 5-piece set of single-ended electric heating pipes, also known as cartridge heaters, is constructed from 316 stainless steel for industrial mold and tooling applications. Designed to be embedded directly into drilled mold holes, these heaters provide reliable and localized thermal transfer.
Technical Features
- Outer Material: 316 Stainless Steel
- Inner Materials: Heating wire, magnesia powder
- Voltage: 220V
- Lead Wire Length: 300mm (11.8 inches)
- High Pressure Strength (unheated): 1500V
- Insulation Resistance (unheated): Greater than or equal to 1.5 MΩ
- Power Allowance: -10% to +5%
- Length Error: ±1.5mm
Applications
Suitable for abrasives heating, stamping dies, hot cutting knives, packaging machinery, injection molds, extrusion molds, rubber molding molds, meltblown molds, hot press molding machinery, semiconductor processing, and uniform heating platforms.
Note: Not applicable to liquid and air heating.
Available Options
Variants combine operating voltage, power rating, and tube dimensions (diameter x length) to fit specific equipment requirements.
Instructions for Use & Safety
- Before installation, measure the electrical continuity and power using a multimeter. Proceed with installation only after verifying proper operation.
- Ensure correct wiring configuration; wiring errors can lead to slow heating performance or component damage.
No reviews yet
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent