Stainless steel immersion tubular heating element with a 1.5-inch Tri-Clamp flange for water tanks, boilers, and brewing systems.
Tri-Clamp Immersion Heaters
Tri-Clamp immersion heaters use a sanitary clamp connection for quick installation and removal from compatible tanks and process vessels. They are commonly used where equipment must be opened regularly for inspection or cleaning.
Select the correct clamp size, voltage, wattage, element length and material. Verify the gasket, clamp and vessel connection are compatible with the liquid, temperature and operating conditions.
Recommended
Stainless steel 240V immersion heater with a 2-inch Tri-Clamp flange and 350mm tube for brewing and liquid heating.
Need an exact replacement?
Send dimensions, voltage, power, material, and photos. We’ll manufacture a heating element for your application.
Fill out the formImmersion water heater featuring a 210mm tube and 2-inch Tri-clamp flange, constructed with 304 stainless steel.
380V 350mm immersion water heater featuring a 2-inch Tri-clamp flange and SUS304 stainless steel construction for brewing and industrial use.
120V 1500W low watt density foldback water heater element with a 2-inch (OD64) tri-clamp flange for sanitary liquid heating.
Tubular electric immersion heating element with a 2-inch Tri-clamp flange, constructed from durable SUS304 stainless steel.
304 stainless steel 1.5-inch Tri-Clamp immersion heating tube designed for brewing equipment, water tanks, and boilers.
Electric immersion water heating element with a 1.5-inch tri-clamp flange and 304 stainless steel pipe for brewing and tank applications.
SUS304 stainless steel tubular electric immersion heater with a 2-inch Tri-Clamp flange for brewing and water tanks.
304 stainless steel tubular immersion heating element featuring a 2-inch Tri-clamp flange and Bakelite cover for fluid and tank heating.
Stainless steel wave-shaped immersion heating element with a 2-inch tri-clamp flange for heating water, oil, and brewing liquids at 240V.
Frequently asked questions
Practical guidance for choosing and using products in this category.
Can an immersion heater be switched on without liquid?
An element designed for immersion must not be energised with its heated section exposed to air. Keep the required heated length covered by the specified liquid throughout operation, following the product instructions. Dry operation can cause rapid overheating and element failure.
Temperature control and suitable low-liquid-level protection should be part of the system design. Keep electrical terminals dry and have the installation checked by a qualified installer.
How do I check whether a tri-clamp heater will fit my vessel?
Compare the heater drawing with the vessel connection, including the ferrule/flange dimensions, clamp and gasket requirements, and the clear opening needed to insert the element. Check the insertion length and allow clearance from the vessel wall, internal coils and other fittings.
Confirm voltage, wattage, phase and the permitted liquid/application as well. The nominal clamp size alone is not enough to establish a complete fit.
Is every stainless steel heater suitable for drinking water, brewing or pool water?
No. Suitability depends on the complete product, including the sheath, seals, fittings, liquid chemistry and operating conditions. A stainless steel grade by itself is not proof of food-contact, potable-water or pool suitability.
Choose a model whose documentation explicitly supports your application. For salt water, chlorinated water, food or drinking-water contact, confirm compatibility before ordering rather than relying on the product name or appearance.