L-shaped right-angle side-exit cartridge heater in 304 stainless steel, operating at 220V with a grounding wire. Supplied in a pack of 2.
Side-Exit Cartridge Heaters
Side-exit cartridge heaters route their electrical leads from the side of the heater, making them suitable where rear clearance is limited or where a right-angle cable path is preferred. They are commonly installed in moulds, dies and compact industrial assemblies.
Check the tube diameter, heated length, voltage, power, lead position and cable length against the available installation space. Mount the heater closely against the heated surface for effective heat transfer.
Recommended
Need an exact replacement?
Send dimensions, voltage, power, material, and photos. We’ll manufacture a heating element for your application.
Fill out the formFrequently asked questions
Practical guidance for choosing and using products in this category.
How do I select the correct cartridge heater size?
Check the sheath diameter and tolerance, insertion length, available mounting depth and lead-exit arrangement against the equipment drawing. Also match voltage, wattage and the required temperature-sensor type if one is built in.
The fit between the cartridge and its bore affects heat transfer. Use the heater manufacturer's specified bore tolerance for the application rather than choosing a part solely because it can be pushed into the hole.