3U tubular electrical immersion heater with DN32 thread, grounding screw, and sensor probe for liquid heating.
Threaded Immersion Heaters
Threaded immersion heaters install through a threaded opening in a tank or vessel and heat compatible liquids directly. They provide a secure, serviceable connection for water heating, brewing, process tanks and industrial liquid-heating systems.
Match the thread standard and diameter, voltage, power, element length and sheath material to the application. Confirm suitable sealing and ensure the active heating area remains immersed while powered.
Recommended
Full 304 stainless steel electric immersion water heating element with threaded connection for solar water tanks.
Need an exact replacement?
Send dimensions, voltage, power, material, and photos. We’ll manufacture a heating element for your application.
Fill out the formIndustrial 304 stainless steel threaded immersion water heater element available in multiple power ratings, voltages, and tube lengths.
DN40 1.5-inch threaded immersion water heating element with built-in sensor probe and grounding screw, available in multiple power ratings and...
Threaded immersion water heater element in 36V or 48V, featuring 304 stainless steel construction and a 200mm tube length for liquid heating.
1" BSP screw-in water immersion heater element made of 304 stainless steel for water boilers.
Screw-in water immersion heater designed for boilers and liquid heating vessels, featuring 304 stainless steel construction.
Copper threaded immersion heating element designed for water tanks, boilers, and industrial heating applications.
DC immersion water heater with 304 stainless steel tube and thread, designed for safe liquid heating applications.
DN25 1" BSP thread immersion heating element made of 304 stainless steel, operating at 240V with selectable power and length options.
Durable 304 stainless steel tubular immersion heating element with a 1-inch NPT thread for liquid heating applications.
Frequently asked questions
Practical guidance for choosing and using products in this category.
Can an immersion heater be switched on without liquid?
An element designed for immersion must not be energised with its heated section exposed to air. Keep the required heated length covered by the specified liquid throughout operation, following the product instructions. Dry operation can cause rapid overheating and element failure.
Temperature control and suitable low-liquid-level protection should be part of the system design. Keep electrical terminals dry and have the installation checked by a qualified installer.
Are BSP, NPT and metric heater threads interchangeable?
No. These are different thread systems, and a similar diameter or nominal size does not mean the fittings will seal or fit correctly. Check the specified thread family, size, pitch and sealing arrangement on both the heater and the equipment.
DN is a nominal size designation, not a measured outside diameter. For example, do not select a mounting hole or adaptor from a DN label alone. If the thread cannot be positively identified, provide the equipment specification and clear measurements before ordering.
Is every stainless steel heater suitable for drinking water, brewing or pool water?
No. Suitability depends on the complete product, including the sheath, seals, fittings, liquid chemistry and operating conditions. A stainless steel grade by itself is not proof of food-contact, potable-water or pool suitability.
Choose a model whose documentation explicitly supports your application. For salt water, chlorinated water, food or drinking-water contact, confirm compatibility before ordering rather than relying on the product name or appearance.