HELP CENTRE

Frequently asked questions

Find practical guidance for choosing, installing, and using our products.

Immersion Heaters

Can an immersion heater be switched on without liquid?

An element designed for immersion must not be energised with its heated section exposed to air. Keep the required heated length covered by the specified liquid throughout operation, following the product instructions. Dry operation can cause rapid overheating and element failure.

Temperature control and suitable low-liquid-level protection should be part of the system design. Keep electrical terminals dry and have the installation checked by a qualified installer.


Are BSP, NPT and metric heater threads interchangeable?

No. These are different thread systems, and a similar diameter or nominal size does not mean the fittings will seal or fit correctly. Check the specified thread family, size, pitch and sealing arrangement on both the heater and the equipment.

DN is a nominal size designation, not a measured outside diameter. For example, do not select a mounting hole or adaptor from a DN label alone. If the thread cannot be positively identified, provide the equipment specification and clear measurements before ordering.


How do I check whether a tri-clamp heater will fit my vessel?

Compare the heater drawing with the vessel connection, including the ferrule/flange dimensions, clamp and gasket requirements, and the clear opening needed to insert the element. Check the insertion length and allow clearance from the vessel wall, internal coils and other fittings.

Confirm voltage, wattage, phase and the permitted liquid/application as well. The nominal clamp size alone is not enough to establish a complete fit.


Is every stainless steel heater suitable for drinking water, brewing or pool water?

No. Suitability depends on the complete product, including the sheath, seals, fittings, liquid chemistry and operating conditions. A stainless steel grade by itself is not proof of food-contact, potable-water or pool suitability.

Choose a model whose documentation explicitly supports your application. For salt water, chlorinated water, food or drinking-water contact, confirm compatibility before ordering rather than relying on the product name or appearance.


Can an immersion heater run continuously?

Only when the selected model and the complete installation are rated for that duty. Continuous operation requires suitable heat removal, the specified liquid coverage, temperature control and protection against overheating or low liquid level.

Check the product duty rating and the tank or process requirements. A wattage rating alone does not confirm that a heater can run unattended or continuously in every installation.


Loading...
Back to top