Product Overview
Semiconductor refrigeration chips utilize the thermoelectric effect of semiconductors. When direct current passes through a thermocouple formed by connecting two different semiconductor materials in series, the cold and hot ends respectively absorb and release heat, making them an ideal choice for temperature cycling applications. No refrigerant is required, and the module can work continuously without pollution sources, rotating parts, sliding parts, vibration, or noise.
Important Safety and Usage Warnings
- Critical Warning: Never connect the module directly to a power supply without proper heat dissipation. Powering on without heat dissipation will cause the sides to heat up rapidly within seconds, permanently burning out the refrigeration fins.
- Thermal Grease: The module must be coated with thermal conductive silicone grease on both surfaces before installation.
- Heat Sinking: Install a suitable radiator or water-cooled cooling device on the heat dissipation surface. The hot surface temperature must not exceed 60 °C.
- Testing: When testing briefly with a dry battery to determine polarity, disconnect immediately within 1 second to avoid overheating damage.
Installation Guidelines
- Apply thermal conductive silicone grease evenly on the heat dissipation surfaces of the semiconductor refrigeration chip.
- Install the module onto the heat sink and place insulation pads or isolation rings around it to prevent condensation.
- Connect to a regulated direct current power supply and provide adequate airflow or liquid cooling at the hot end.
- Keep the cooling surface temperature around 20 °C when necessary to minimize dew condensation, or use protective insulation.
Available Options
This listing offers multiple semiconductor refrigeration chip models and dimensions (such as TEC1-12704, TEC1-12705, TEC1-12706, and various 20x20mm, 30x30mm, and 40x40mm sizes) to match specific power, voltage, and cooling requirements.
Package Contents
- 1 x Peltier Refrigeration Plate
No reviews yet
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent